The halt action explicitly terminates OmniMark from within a program. When it is encountered, OmniMark acts as if the end of all input has been reached. No further OmniMark rules or actions are performed. Processing of all output files is completed, including processing of referents.
The halt-everything action can be used to immediately halt an OmniMark program, leaving referents unresolved without any errors being reported.
OmniMark 7.1.2 Documentation Generated: June 28, 2005 at 5:44:37 pm
If you have any comments about this section of the documentation, send email to [email protected]
Copyright © Stilo Corporation, 1988-2005.
