No PROCESS-START, PROCESS, or PROCESS-END rules were specified, so no action will be taken.
Explanation
In this kind of program, at least one PROCESS rule is needed to cause
the eventual firing of other rules. A common cause of this message is that
a V2 down-translation did not start with the DOWN-TRANSLATE keyword.
(this was the V2 default).
OmniMark 6.5 Documentation Generated: December 23, 2002 at 6:26:03 pm
If you have any comments about this section of the documentation, send email to [email protected]
Copyright © OmniMark Technologies Corporation, 1988-2002.
